Incredibly Soft & Cuddly Shawl - Free Easy Pattern

Wrap yourself in a cozy warmth with a soft & cuddly triangle shawl you can wear in multiple ways.

Go with Super Bulky Bouclé Type Yarn

For this piece, assuming you want to create a light & fluffy fabric to wrap yourself in, I recommend picking a super bulky bouclé type yarn that cradles a lot of air as you knit it into a fabric. In fact, I started out this project to make a winter blanket because I was able to get hold of Purl Soho’s Fiddlehead (100% alpaca yarn with bouclé like effect) on sale.

Size is Entirely Customizable

When I started knitting the blanket per Purl Soho’s instructions, I wasn’t sure of the size. Because this pattern starts at the corner and keep increasing on both sides, I figured I can stop it whenever I want and add another color yarn (which I had at hand) if I ran out of the first color. Then because I liked the way it felt on my fingers & skin while knitting, and I was a bit tired of repeating the same simple pattern, I decided to stop it before starting the decrease phase as a blanket would require you to do. So mine is a rather large shawl because I was quite far along when I made the decision, and ended up with approximately 38″ (shorter triangle side) x 38″ x 54″ (longer triangle side). Naturally you can be more deliberate and decide on your sizing far better than I did!

Knitting Instructions

Materials: For this example of 38 x 38 x 54 shawl, about 300 yrds of super bulky yarn. In this case 4-1/2 skeins of Purl Soho’s Fiddlehead.

US#11 (8mm) long (47 cm or longer) circular needles.

L-11 or 8mm crochet hook.

Gage: 9 stitches and 18 rows = 4 inches in garter stitch

Abbreviations:

st(s) = stitch(es); R = row; k = knit

Note: kfb or knit front and back is a common increase stitch often used in raglan or other continuous increase patterns. Here you would knit twice into the same stitch – a regular knit stitch through the front of the loop and before transferring the stitch, you would knit one more time through the back loop of the same stitch, and then transfer.

Knit every row starting at the bottom corner and increase one stitch on both sides on every other row:

  • Cast on 3 stitches.
  • R1 (right side) – kfb (see the note abov), k1, kfb -> 5 sts.
  • R2 and every subsequent wrong side row – knit.
  • R3 and every subsequent right side row – k1, kfb, knit to the last two sts, kfb, k1 -> 5 sts. 2 sts. increased.
  • Repeat R2 & R3 as many times as you’d like, ending with the wrong side. I repeated 50 more times, ending up with 105 sts.
  • Loosely bind off, cut the yarn and weave the end

Optional: crochet the loop trims and cords

  • Starting with one of the corners of the longer triangle side, first crochet an approx. 12″ cord.
  • The cords are optional – I like them because they make it easier for you to grab the ends and tie after wrapping it around your shoulder once or a few times.
  • I used a basic chain st. forward & back cord, and you can make a fancier version if you’d like.
  • After one cord is completed, crochet chain loop trims on both of shorter triangle sides.
  • I used 7/5 ratio, i.e., 7 chain sts per every 5 rows.
  • When you reach the other corner of the longer triangle side, make another crochet cord.

Enjoy wrapping around and draping the warm & cushy softness!

About The Author

MayumiW

Leave A Comment

Your email address will not be published. Required fields are marked *